The ”UV-Water-PTFE” is a waterproof (10 bar or 145 psi) sensor with a G1/4” thread to be
used in pressurized water systems. The sensor housing is made of Teflon (PTFE).
The sensor is suited for low pressure lamps.
The sensor contains integrated electronics and is
shielded against electromagnetic interference. Sensor configuration options are spectral
response, signal output type and measuring range. The signal output is either a voltage of 0 to 5 V, a current of 4 to 20 mA, CAN bus interface or USB. The UV sensor is available with a NIST or PTB traceable calibration.
Spectral Sensitivity: Broadband UV, UVA, UVB, UVC, UV-Index, Bluelight and UV+VIS
Signal Output: 0 to 5 V or 4 to 20 mA or CAN bus signal (125kbit/s) or USB
Current Consumption: for 0 to 5 V = < 30 mA / for 4 to 20 mA = signal out / digital = < 17 mA
Connections: cable = 2 m cable with tinned leads on free end
plug = 5 pin male connector with 2 m cable with tinned leads on free end
CAN = 2 m cable with 8 pin male connector (to converter or else)
USB = with 1.5 m cable with USB-A plug
Measuring Range: between 1 nW/cm2 to 1 µW/cm2
and 20 mW/cm2 to 20 W/cm2 for analog or 100 µW/cm2 to 20 W/cm2 for digital sensors (see questionaire sheet)