UV-SURFACE
Standard surface-mount 180o FOV UV Sensor
The ”UV-Surface” sensor is used for UV radiation reference measurements on surfaces exposed to UV light. The sensor contains integrated electronics and is shielded against electro-magnetic interference.
Sensor confi guration options are spectral response, signal output type and measuring range. The signal output is either a voltage of 0 to 5 V, a
current of 4 to 20 mA, CAN bus interface or USB. The UV sensor is available with a NIST or PTB traceable calibration. Cosine correction is available on request.
Technical specifications
Spectral Sensitivity: Broadband UV, UVA, UVB, UVC, UV-Index, Bluelight and UV+VIS
Signal Output: 0 to 5 V or 4 to 20 mA or CAN bus signal (125kbit/s) or USB
Current Consumption: for 0 to 5 V = < 30 mA / for 4 to 20 mA = signal out / digital = < 17 mA
Connections: cable = 2 m cable with tinned leads on free end
plug = 5 pin male connector with 2 m cable with tinned leads on free end
CAN = 2 m cable with 8 pin male connector (to converter or else)
USB = with 1.5 m cable with USB-A plug
Measuring Range: between 1 nW/cm2 to 1 µW/cm2 and 20 mW/cm2 to 20 W/cm2 for analog or 100 µW/cm2 to 20 W/cm2 for digital sensors (see questionaire sheet)